The purpose of this lab was too be able to analyze, build, and test a multiple-source circuit. As part of our pre lab we had to analyze the circuit on the whiteboard using a new method of nodal analysis. Nodal analysis is a favorable method because it results in a simpler system of equations compared to KVL or Mesh Analysis. Below are our calculations.
The voltage V1 we calculated to be 2.424 V. The picture below shows the reading of our actual circuit.
Again for V2, we calculated it to be 4.424 V. Below is our measurement.
The three voltage sources and ground in the back of the circuit, along with the three different resistors.
Our error was minimal and negligible.
No comments:
Post a Comment